Gravity: Steam Sensor


In stock

Categories: , Tags: ,


This is a steam(water)sensor from DFRobot. This steam sensor can be connected to the Arduino IO Expansion shield directly. The output voltage will increase when the humidity of the sensor surface goes up.

Notice:The new version of analog sensor port pin mapping has been changed as the following two features.

Warning: The connector is not waterproof, please be careful not to put the connector directly in water.

Simple rain detector
Cheap steam level switch
Touch sensor based on humidity

Power supply: 3.3v or 5v
Output voltage signal: 0~4.5v(@5v) or 0~3.0v(@3.3v)
Pin definition:
Analog output(Blue wire)
GND(Black wire)
Power(Red wire)
Size: 30x20x6mm (0.18×0.79×0.24″)


There are no reviews yet.

Be the first to review “Gravity: Steam Sensor”

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.